64
6. Selectați tipul de aparat
pe care îl configurați
5. Apăsaţi “+ Add Device ”
7
Network configuration by Bluetooth scan
Note: Make sure the bluetooth of your mobile device is
working.
Press “ + Add Device ”
Press “Scan for nearby
devices”
1
2
multe informatii va rugam sa accesati Manualul de
Utilizare al unitatii dumneavoastra).
4. Cand aparatul afiseaza mesajul «AP», asta inseamna
ca functia wireless a dezumdificatorului a intrat deja in
modul «AP»
Adaugati manual un dispozitiv nou:
2
5
Choose the network
configuration method.
3
Choose the “ Scan the
QR code ” method. Sacn
the QR code on the unit.
4
NOTE: Steps 3 and 4 are applicable to Android system only. iOS system does not need
these two steps.
Please follow the above steps to enter “AP” mode.
Choose Method
Back
Scan QR code on the unit
Manual Setup
Note:Wait5-10 seconds while your device is in
AP mode before scanning the QR code.
Network configuration by select appliance type :
If the bluetooth network
cofiguration is failure, please
select the appliance type.
1
When choose the “Manual
Setup” method(Android).
Connect to the wireless
network(iOS)
5
To Next Page
Loading...
Need help?
General
