What to do if my INVENTOR EVI-09 unit can not run?
If your INVENTOR Air Conditioner unit doesn't run, check if the power has been shut down, the power plug is loose, or the circuit protection device has tripped. Also, verify if the voltage is too high or low (tested by professionals) and ensure the TIMER is correctly used.
Why is the cooling or heating efficiency of my INVENTOR Air Conditioner not good?
If the cooling or heating efficiency of your INVENTOR Air Conditioner is not good, consider the following: Is the temperature setting suitable? Are the inlet and outlet vents obstructed? Is the filter dirty? Are the windows and doors closed properly? Is the fan speed set at low? Are there any heat sources in the room?
Why is there an unusual smell coming from my INVENTOR EVI-09 outlet?
An unusual smell from your INVENTOR Air Conditioner outlet could be due to smells accumulated in the ambient. Try cleaning the filter. If the problem persists, the air conditioner may need cleaning; in that case, contact an authorized maintenance center.
Why is there water leakage in the outdoor unit of my INVENTOR Air Conditioner?
Water leakage in the outdoor unit of your INVENTOR Air Conditioner can occur for several reasons. When running in COOL mode, condensation may form on the pipe and pipe connections. In Auto Defrosting mode, ice thaws and flows out. In HEAT mode, water adhered to the heat exchanger may drip off.
Why is my INVENTOR Air Conditioner indoor unit not delivering air?
In HEAT mode, the indoor unit may stop delivering air to prevent blowing cool air when the indoor heat exchanger temperature is very low (within 2 minutes). Also, in HEAT mode, if the outdoor temperature is low or humidity is high, frost can form on the outdoor heat exchanger, causing the unit to automatically defrost, and the indoor unit will stop blowing air for 3-12 minutes. During defrosting, water may flow out or vapor may be produced. Finally, in dehumidifying mode, the indoor fan may stop to prevent condensed water from vaporizing again and to restrain temperature rising.
Why does my INVENTOR EVI-09 Air Conditioner emit mist from the air outlet vent in COOL mode?
Mist emitted from the air outlet vent in COOL mode of your INVENTOR Air Conditioner happens because the room air is swiftly cooled down. After running for a while, the indoor temperature and humidity will decrease, and the mist will disappear.
What causes the noise from the indoor unit emitted by my INVENTOR EVI-09 Air Conditioner?
The noise from the indoor unit of your INVENTOR Air Conditioner could be the sound of the fan or compressor relay switching on or off. It may also occur when defrosting starts or stops, due to refrigerant flowing in the reverse direction.
Why is there moisture on the air outlet vent of my INVENTOR Air Conditioner?
If your INVENTOR Air Conditioner runs under high humidity for a long time, moisture may condense on the air outlet grill and drip off.
Why does my INVENTOR Air Conditioner make a creaking noise when starting or stopping?
The creaking noise heard when starting or stopping your INVENTOR Air Conditioner is due to the deformation of plastic caused by temperature changes.
What is the sound of water flow I hear during the operation of my INVENTOR EVI-09?
The sound of water flow you hear during the operation of your INVENTOR Air Conditioner is due to refrigerant flowing and is not a malfunction.
Essential safety guidelines and precautions for operating the air conditioner correctly and safely.
Information on how to use the air conditioner, including working principles and special functions like defrosting.
Identifies and describes the components of the indoor and outdoor units of the air conditioner, including parts and ports.
Detailed explanation of the buttons and functions of the wireless remote control for operating the air conditioner.
Instructions for operating the unit using the manual switch when the remote control is lost or broken.
Guidance on cleaning the front panel and air filter of the air conditioner for regular maintenance and optimal performance.
Common problems and their solutions for diagnosing and fixing issues with the air conditioner, preventing service calls.
Important guidelines and requirements for correctly installing the air conditioner unit to ensure safety and proper function.
Visual guide showing required clearances and spacing for proper installation of indoor and outdoor units.
Step-by-step instructions for mounting and connecting the indoor unit, including piping and wiring.
Instructions for wiring, air purging, and leakage testing for the outdoor unit installation.
Procedures to verify correct installation and perform initial testing to ensure the unit operates properly.
Instructions for installing, cleaning, and maintaining the healthy filter for optimal air quality.
General| Energy Class Cooling | A++ |
|---|---|
| Energy Class Heating | A+ |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Cooling Capacity | 9000 BTU |
| Noise Level (Indoor) | 24 dB |
| Operating Temperature (Cooling) | 18-43 °C |
| Dimensions (Outdoor Unit) | 700x275x550 mm |
To Next Page
