To Next Page
J
Jimmy ArmstrongAug 1, 2025
Why does my INVENTOR M2GHP290-12 make a gurgling sound?
- WWanda RojasAug 1, 2025
This gurgling sound in your INVENTOR Air Conditioner is normal. It is caused by the flow of refrigerant inside the unit.
Why does my INVENTOR M2GHP290-12 make a gurgling sound?
This gurgling sound in your INVENTOR Air Conditioner is normal. It is caused by the flow of refrigerant inside the unit.
Why is my INVENTOR M2GHP290-12 Air Conditioner not cooling well?
If your INVENTOR Air Conditioner isn't cooling well, there could be several reasons: 1. A dirty air filter: Turn off the unit and clean the filter as per the instructions. 2. A blocked or disconnected exhaust pipe: Turn off the unit, disconnect the hose, check for blockages, and reconnect it. 3. Low refrigerant: Contact a service technician to inspect and refill the refrigerant. 4. Temperature setting is too high: Lower the set temperature. 5. Open windows or doors: Ensure all windows and exits are closed. 6. Room size too large: Verify the cooling area is appropriate for the unit. 7. Heat sources in the room: Remove any heat sources if possible.
General| Brand | INVENTOR |
|---|---|
| Model | M2GHP290-12 |
| Category | Air Conditioner |
| Language | English |
Ensure proper grounding, correct voltage, and avoid extension cords or combined outlets to prevent shock or fire.
Warnings on ignition sources, penetration, and awareness of flammable refrigerant gas risks.
Guidelines for installation and operation in well-ventilated areas based on room size for R290/R32 units.
Requirements for certified technicians, symbol meanings, and key notes on handling flammable refrigerants.
Safety checks, work procedures, area monitoring, fire extinguishers, and ignition source control during servicing.
Ensuring proper ventilation, checks to refrigeration and electrical components for safe operation.
Safety checks for electrical components and repairs to intrinsically safe components.
Methods for detecting flammable refrigerants and handling leaks, including evacuation procedures.
Steps for performing repairs, charging systems, and ensuring safety during these processes.
Procedures for safe decommissioning, refrigerant recovery, and equipment labeling.
Best practices for recovering refrigerants from systems for servicing or decommissioning.
Solutions for problems like the unit not turning on, not cooling, noise, or gurgling sounds.
