Swing button
Used to initiate the Auto swing feature. When
the operation is ON, press the SWING button
can stop the louver at the desired angle.
Timer button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the + & - buttons. The timer on/o
indicator light illuminates under the timer
on/o settings.
Mode button
Choose the desired operating mode. By
pressing the MODE button each time an
operation is selected in the following order:
AUTO, COOL, DRY, FAN and HEAT (cooling
only models without). Indication led will
illuminate under the desired MODE setting.
Up (+) and Down (- ) buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/1°F (or 2 °F)
increments in a range of 17°C/62°F to
30°C/86°F (or 88°F) or the TIMER setting in a
range of 0~24hrs.
NOTE: The remote control may display the
temperature in both Fahrenheit or Celsius.
To change press and hold the up/down
buttons for 3 sec.
Fan
Control the fan speed. Press to select the
fan speed in four steps- LOW, MED, HIGH
and AUTO. The fan speed indicator light
illuminates under dierent fan settings.
When select AUTO fan speed, all the fan
indicator lights turn dark. On some models,
when select AUTO fan speed, all the fan
indicator lights illumiante(optional).
Sleep(Eco) button
Used to initiate the SLEEP/ECO operation.
Power button
Power switch on/o.
LED display
Shows the set temperature in °C or °F
("°F" no display for some models) and the
Auto- timer settings. While on DRY and FAN
modes, it shows the room temperature.
Shows Error codes and protection code:
E1- Room temperature sensor error.
E2- Evaporator temperature sensor error.
E3- Condenser temperature sensor error
(on some models).
E4- Display panel communication error.
EC- Refrigerant leakage detection
malfunction (on some models).
P1- Bottom tray is full- Connect the drain
hose and drain the collected water away.If
protection repeats,call for service.
Note: When one of the above malfunctions
occurs, turn o the unit, and check for
any obstructions. Restart the unit, if the
malfunction is still present, turn o the
unit and unplug the power cord. Contact
the manufacturer or its service agents or a
similar qualied person for service.
Exhaust hose installation
The exhaust hose and its adaptor should
be installed or removed according to the
usage mode. Under COOL,HEAT(heat pump
type) or AUTO mode the exhaust hose must
be installed, under FAN,DEHUMIDIIFY or
HEAT(electrical heat type) the exhaust hose
should be removed.
To Next Page
Loading...
Need help?
General
