3
|Safety Precautions
WARNING: “Safety Hazard Symbol”, it is very important to please pay close attention to the
below, to avoid any serious injury.
WARNING: To avoid any serious injuries or possible unit damage, please read carefully and
follow the below safety guidelines:
- The installation of this unit must be according to this manual, as improper installation may cause
water leakage, electrical shock or even a re.
- Use only included parts and accessories, and the specied tools for the installation of your
portable air conditioner. The use of parts that are not included in this package may result to water
leakage, electrical shock, re, injury and possible property damage.
- Be certain that the outlet in use, is properly grounded and that of the correct voltage. The three-
prong power cord is designed to protect against shock. Information regarding voltage may be
found on the nameplate of your unit.
- This unit must be connected to a properly grounded power supply. If the power supply is not
grounded or protected by a fuse or a circuit breaker (the correct fuse is determined by the
maximum current of the unit, which is located on the nameplate of the device) it is strongly
advised to have a professional qualied electrician install the proper power supply.
- Install on a at and sturdy oor. Failure to install in this manner could result in damage, excessive
noise and even vibration.
- This device should be placed clear of any obstructions to ensure its correct and proper function
and to avoid any possible hazards.
- DO NOT use an extension cord or modify the length of the cord in any way, to power the unit.
- DO NOT combine a single power outlet with other electrical appliances. Irregular power supply
may cause electric shock and a possible re.
- DO NOT install this unit in a very humid room such as a bathroom facility or a laundry room.
Excessive exposure to water may cause the internal electrical components to short circuit.
- DO NOT install in a location exposed to a combustible gas, as this could result to a re.
- The device is equipped with casters for easy mobility. It is suggested not to be used on thick
carpets, as this may cause its tripping.
- DO NOT operate this unit if it has been dropped or damaged in any way.
- For models with heating capabilities, there should be at least 1 meter clear space from any
combustible materials.
- Do not touch this unit with wet or damp hands or while barefoot.
- If the portable air conditioner is knocked over while operating, turn o and unplug from the power
socket immediately. Examine the device ensuring there is no visible damage. If you suspect that
the unit has been damaged, it is necessary to contact a technician or customer support for further
assistance.
- In the event of a thunderstorm, it is suggested to turn o the unit as there is the possibility of
damage due to unsteady power supply.
- Your portable air conditioner should be operated in such a manner, so as to be protected from
moisture. Do not position the unit in an area where possible tripping into water may occur. In this
event, unplug immediately.
- All wiring must be performed strictly in accordance to the wiring diagram which is located
internally.
- The circuit board of the unit (PCB) is designed with an overcurrent protection fuse. Specications
of the fuse are printed on the circuit board, in this manner: T3.15A/250V.
To Next Page
Loading...
Need help?
General
