INVT GD20-7R5G-4-EU

Goodrive20-EU series VFD Product overview
12
Figure 2-3 Product structure (3PH 400V, ≤2.2kW)
No.
Name
Description
1
External keypad port
Connect the external keypad
2
Port cover
Protect the external keypad port
3
Cover
Protect the internal parts and components
4
Hole for the sliding cover
Fix the sliding cover
5
Trunking board
Protect the inner components and fix the cables of the
main circuit
6
Name plate
See section 2.5 "Name plate" for details.
7
Potentiometer knob
Refer to chapter 4 "Keypad operation procedure".
8
Control terminals
See chapter 3 "Installation guide" for details.
9
Main circuit terminals
See chapter 3 "Installation guide" for details.
10
Screw hole
Fix the fan cover and fan.
11
Cooling fan
See chapter 6 "Fault tracking" for details.
12
Fan cover
Protect the fan
13
Bar code
The same as the bar code on the name plate
Note: The bar code is on the middle shell which is under
the cover.
Note: In above figure, the screws at 4 and 10 are provided with packaging and specific
installation depends on the requirements of customers.
Below is the layout figure of the VFD (Three phase 400V, ≥4kW) (take the VFD of 4kW as the
example).