INVT GD300-1R5G-4

Goodrive300 Series VFD Function parameters
71
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
temporarily
34: DC brake
35: Shift the motor 1 into motor 2
36: Shift the command to the keypad
37: Shift the command to the terminals
38: Shift the command to the communication
39: Pre-magnetized command
40: Comsumption power clear
41: Comsumption power holding
42–60: Reserved
61: PID pole switching
62–63: Reserved
P05.10
Polarity
selection of
the input
terminals
The function code is used to set the polarity of the
input terminals.
Set the bit to 0, the input terminal is anode.
Set the bit to 1, the input terminal is cathode.
BIT0
BIT1
BIT2
BIT3
BIT4
S1
S2
S3
S4
S5
BIT5
BIT6
BIT7
BIT8
S6
S7
S8
HDI
Setting range: 0x000–0x1FF
0x000
○
P05.11
ON-OFF filter
time
Set the sample filter time of S1–S8 and HDI
terminals. If the interference is strong, increase
the parameter to avoid the disoperation.
0.000–1.000s
0.010s
○
P05.12
Virtual
terminals
setting
0x000–0x1FF(0: Disabled, 1: Enabled)
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: S5 virtual terminal
BIT5: S6 virtual terminal
BIT6: S7 virtual terminal
BIT7: S8 virtual terminal
BIT8: HDI virtual terminal
Note: After a virtual terminal is enabled, the state
of the terminal can only be modified through
0x000
◎