Installation
Rack Online 1-3k UPS User Manual 9
5. Installation
NOTICE：UPS operation in sustained temperature outside the range of 14-25°C (59°-77°F)
reduces battery life.
5.1 Unpacking and Inspection
1) Unpack the packaging and check the package contents. The shipping package contains:
● 1 UPS
● 1 user manual
● 1 Input Cable
● 1 RS232 Cable
● 2 Bracket Ear
● 1 Battery Cable (For Long backup model only)
2) Inspect the appearance of the UPS to see if there is any damage during transportation.
Do not turn on the unit and notify the carrier and dealer immediately if there is any
damage or lacking of some parts.
5.2 Mechanical Installation
Two installation modes are available: tower installation and rack installation, depending
on available space and use considerations. You can select an appropriate installation
mode according to the actual conditions.
5.2.1 Notes for installation
1) The UPS must be installed in a location with good ventilation, far away from water,
inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not blocked so as to
ensure good ventilation.
3) Condensation to water drops may occur if the UPS is unpacked in a very low
temperature environment. In this case it is necessary to wait until the UPS is fully
dried inside out before proceeding installation and use. Otherwise there are hazards
of electric shock.
5.2.2 Tower Installation
Various installation configurations are available: single UPS, single UPS with single or
multiple battery cabinets. Their installation methods are all the same.
To Next Page
Loading...
Need help?
General
