Battery Maintenance
20 Rack Online 1-3k UPS User Manual
8. Battery Maintenance
8.1 Battery maintenance
1-3KVA UPS only requires minimal maintenance. The batteries used for standard models are
value regulated, sealed lead-acid, maintenance free battery. When being connected to the
utility power, whether the UPS is turned on or not, the UPS keeps charging the batteries and
also offers the protective function of overcharging and over-discharging.
lThe UPS should be charged once every 4 to 6 months if it has not been used for a long
time.
lIn the regions of hot climates, the battery should be charged and discharged every 2
months. The standard charging time should be at least 12 hours.
lUnder normal conditions, the battery life lasts 3 to 5 years. In case if the battery is found
in bad condition, earlier replacement should be made.
lBattery replacement should be performed by qualified personnel.
lReplace batteries with the same number and same type of batteries.
lDo not replace the battery individually. All the batteries should be replaced at the same
time following the instructions of the battery supplier.
8.2 Replacing Internal Battery Pack
Battery replacement procedures
Step 1: Gently remove the front plastic bezel cover from the UPS.
Step 2: Loosen and remove the screws on the battery door, as shown in Fig.7-1. Lay
the battery door aside for reassembly.
To Next Page
Loading...
Need help?
General
