Need help?Do you have a question about the Ioline I/S 110 and is the answer not in the manual?
Information about Ioline and SmarTrac trademarks and other product names.
Ioline Corporation's warranty disclaimer for the manual and product.
Operator's responsibility for cutter performance and safety precautions.
How to get assistance with Ioline products via local dealers, service centers, or direct contact.
Read safety guidelines before operation; observe precautions for sharp blades and moving parts.
Avoid taut material, use Autoloop, handle blades carefully due to sharpness and brittleness.
Do not repair without authorization, disconnect power for adjustments, keep clear of moving parts and jewelry.
Diagram identifying key components of the Ioline SmarTrac I/S cutter.
Diagram identifying key components of the Ioline SmarTrac SC cutter.
Instructions for safely unpacking the cutter and listing essential tools for setup.
Steps to attach feet to the cutter stand legs for stability and leveling.
Procedure for assembling the cutter stand by connecting the cross-member to the legs.
Guide for inserting media rollers into the stand legs, accommodating different media sizes.
Instructions for placing the cutter unit onto the assembled stand or cradle.
How to insert screws to secure the cutter to the stand or cradle feet.
Instructions for removing packing materials and securing straps to complete assembly.
Guide for connecting power and communication cables (serial or USB) to the cutter and computer.
Instructions for installing the Ioline Control Center software and necessary USB drivers.
Instructions for placing a roll of material onto the media rollers and threading it.
Guide for positioning pinchwheels over drive shaft markers for optimal material handling.
Steps to ensure material is flat and square in the machine before cutting.
How to position material with slack and align it correctly for cutting.
Detailed steps for inserting a blade into the holder and securing it in the carriage jaw.
Procedure for setting optimal blade exposure and force using test cuts.
Performing final test cuts and setting the cutter's origin point for operation.
Details on how to contact Ioline Corporation for product assistance and service.
To Next Page
General
