Need help?Do you have a question about the Ioline SmarTrac I/S Series and is the answer not in the manual?
Trademarks, warranty, and liability limitations for the manual and product.
Contact information and support channels for Ioline products.
Introduction to the Ioline SmarTrac cutter and required components for cutting.
Steps to connect the cutter, install software, drivers, and configure ports.
Explanation of the cutter's keypad functions and button operations.
Covers Arrow keys, Set Origin, Speed, Force, and Test Cut functions.
Overview of the Control Center, its menus, and screen options for settings.
Guidelines for cutting, material alignment, and using features like Tangential and Contour Cutting.
Steps to test communication between the computer and plotter via parallel or serial ports.
Specific tests for the cutter and computer serial (COM) ports.
Solutions for plot starting point, repeat function, and no plot response errors.
Addresses erratic printing, blade problems, corner alignment, weeding, and tracking issues.
Explains LED error codes and troubleshooting for parallel port connections.
Instructions for replacing the cutter blade and cleaning the drive shaft.
Procedures for size calibration and sensor calibration for accurate contour cutting.
Resources and contact information for customer support and service.
Regulatory information regarding radio frequency emissions and compliance.
To Next Page
General
