Ioline I/S 60 User Manual

1
Quick Start Guide
Ioline SmarTrac™
I/S Series SC Series
I/S 60, 85, 110, 130 and 100 System SC-40 & -48

Ioline I/S 60 Specifications

General

Max. Cutting Width	60 inches
Max. Media Width	62 inches
Cutting Width	60 inches
Cutting Force	600 grams
Drive Technology	Servo motor
Contour Cutting	Yes
Resolution	0.0005 inches
Interface	USB, Ethernet
Power Supply	100-240V AC, 50/60Hz

Summary

Safety and Cautions

Quick Setup

Step 1: Unpack

Instructions for unpacking the cutter, stand parts, and accessory kit.

Step 2: Assemble the Stand

Steps to assemble the stand for the cutter.

Step 3: Attach the Stand or Cradle

Guide for attaching the cutter unit to the stand or cradle.

Step 4: Finish Installation

Steps for completing the installation process.

Install the Software

Instructions for installing the Ioline Control Center software.

Step 5: Prepare to Cut

Procedures for preparing the cutter for the cutting process.

Load the Material Roll

Instructions on how to load a material roll onto the media rollers.

Position the Pinchwheels Over the Drive Shaft

Square the Material

Position the Material

Insert a Blade, Load the Holder in the Jaw

Adjust the Blade Exposure and Force