Drive Controls and Indicators
The Iomega CD-
RW drive has controls and jacks on the front and back panel of the drive that are labeled with various indicators. The following section describes these controls and
indicators.
1. The
View Window
lets you view the CD.
2. The
Write status LED (left)
flashes red if the drive is reading from or writing to a disc.
3. The
Power LED (right)
will be green if the drive is receiving power.
4. The
Eject Button
opens the Iomega CD-RW drive to insert or remove a disc.
5. The
Emergency Eject Hole
opens the Iomega CD-RW drive to remove a disc during a power failure.
6. The
Volume Control
raises and lowers the volume output.
7. The
Audio Jack
enables you to use the provided audio cable to connect to an audio port on your computer and listen to audio CDs.
Iomega CD-RW USB Drive Power
When you shut down your system, you can disconnect power to the Iomega CD-RW drive; however, it will not harm the drive to leave it powered up. Disconnecting the power
supply from the drive is an easy way to power down the Iomega CD-RW drive.
If you disconnect power from the drive, but leave the power supply plugged in, the power drawn is less than 2 Watts. To power down completely, plug the power supply into your
computer's power strip and use the switch on the power strip to power down both the computer and your Iomega CD-RW drive.
Identifying the Drive Letter Assigned to your Iomega CD-RW Drive (PC Only)
If you have more than one CD drive connected to your computer, you might not know which drive letter is assigned to your Iomega CD-RW drive.
To find the drive letter for your Iomega CD-RW drive, double-click the
icon on your desktop. Right-click the
icon and select
from the menu. The tray
To Next Page
Loading...
Need help?
General