7 8
TA750
CLEAN FILTER LIGHT
If the unit has not been regularly cleaned and an excessive
amount of dirt has collected on the permanent ionic filter,
the unit will shut down and the blue light will turn on. This
light will turn on every 8 weeks to remind you to clean the
filter. Simply clean the permanent ionic filter by following
the “CLEANING & MAINTENANCE” section of this manual
and when complete, press the ON/OFF and DIM buttons
together to reset.
CLEANING THE IONIZER
For maximum performance we recommend that you clean
the ionizer each time you clean the Permanent Ionic Filter.
Locate the Ionizing cleaning switch on the front grill of the
Ionic Pro® Platinum. See Figure 3.
Push the rod towards the center of the grill. The rod will
move about 0.5 inch forward before it will come to a stop.
Release the rod. Repeat this 2 to 3 times.
CLEANING & MAINTENANCE
If you hear excessive noise or static coming from your Ionic
Pro® Platinum it generally indicates that the product needs to be cleaned. Turn
off your Ionic Pro® Platinum, unplug the cord and carefully follow the cleaning
instructions in the “CLEANING & MAINTENANCE” section of this manual.
Keep the Ionic Pro® Platinum functioning properly by cleaning the permanent
ionic filter and pre-filter after every 8 weeks of use as recommended. More
frequent cleaning will be necessary if the unit is located in an area with a high
level of airborne contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing the Ionic Pro® Platinum to candle, oil lamp, fireplace soot, and smoke is
not recommended and will require the collection blade assembly and pre-filter to
be cleaned more frequently.
HELPFUL TIP: If your unit doesn’t work and the CLEAN FILTER light is on,
it’s time to clean the filters.
PREPARING TO CLEAN:
1. Turn off and unplug your Ionic Pro® Platinum and let it rest for 60 seconds.
2. Remove the permanent ionic filter by taking hold of the handle
and lifting upwards. See Figure 4.
3. After removing the permanent ionic filter from the unit, immediately discharge
residual electricity by touching blades to an electrical ground such as a water
pipe or metal faucet.
4. Remove the pre-filter from the ESP cell. See Figure 7.
CLEANING AND MAINTENANCE CLEANING AND MAINTENANCE
Figure 4
Figure 3
To Next Page
Loading...
