9 10
TA750
CLEANING THE PERMANENT IONIC FILTER:
DISHWASHER
1. Put the permanent ionic filter into the dishwasher— making sure not to damage
or bend the blades.
2. Remove from dishwasher at the end of the cleaning cycle.
3. VERY IMPORTANT: Ensure that the permanent ionic filter is thoroughly dry
before installing it into the purifier and resuming use.
4. Always make sure your air purifier is turned off and unplugged before attempting
to vertically re-insert the permanent ionic filter.
HANDWASH
1. Place the permanent ionic filter into warm, soapy water and let stand for
approximately 10 minutes. See Figure 5.
2. Remove from water and rinse with warm water. Repeat as necessary. Make sure
not to damage or bend the blades. See Figure 6.
3. You may use a household degreaser for severe smoke or grease build up on the
permanent ionic filter. Please follow the instructions for the household degreaser.
4. VERY IMPORTANT: Wait until the permanent ionic filter is thoroughly dry before
re-inserting it into the purifier and resuming use.
5. Always maker sure your air purifier is turned off and unplugged before attempting
to vertically re-insert the collection blade assembly and pre-filter.
NOTE: If you insert a wet part, the fan will not turn on and the CLEAN FILTER light
will go on. Simply take out the part and let it dry.
CLEANING THE PRE-FILTER:
NOTE: The pre-filter is attached to the back side of the permanent ionic filter.
See Figure 7.
1. When in use, the pre-filter removes larger particles from the air circulating
through your Ionic Pro® Platinum.
2. It can either be hand-washed in cold water or vacuumed.
3. However you clean it, make sure it is absolutley dry before attempting to
vertically re-insert it into your air purifier and resuming use.
4. Always make sure your air purifier is turned off and unplugged before
attempting to vertically re-insert the permanent ionic filter or pre-filter.
IMPORTANT DRYING WARNING
To avoid damaging your air purifier, make sure the permanent ionic filter and
pre-filter are completely dry and free of all moisture before attempting to vertically
re-insert them into your air purifier and resuming use.
NOTE: If you insert a wet part, the fan will not turn on and the CLEAN FILTER light
will go on. Simply take out the part and let it dry.
Always make sure your air purifier is turned off and unplugged before attempting to
vertically re-insert the permanent ionic filter and pre-filter.
Figure 5 Figure 6
CLEANING AND MAINTENANCE CLEANING AND MAINTENANCE
Figure 7
To Next Page
Loading...
