iOptron CEM26 - Returning Mount to Zero Position; Return Mount to Zero Position

20
STEP 11. Return Mount to Zero Position
After polar alignment and balancing OTA, return the mount to Zero Position. The Zero Position is the
position with the CW shaft pointing toward the ground, OTA at the highest position with its axis parallel to
the polar axis and the OTA pointing to the Celestial Pole.
To set the mount to Zero Position, press MENU=>”Zero Position”=>”Set Zero Position”. Release
the Gear Switch to manually return the mount to Zero Position, or use the hand controller to slew the mount
to Zero Position. Press ENTER to confirm the zero position.
Set the Zero Position or check the Zero Position by using MENU=>”Zero Position”=>”Goto Zero
Position” before each session.