Do you have a question about the iOptron CEM26 and is the answer not in the manual?
Payload Capacity | 26 lbs (11.8 kg) |
---|---|
RA Worm Wheel | 180 teeth |
DEC Worm Wheel | 180 teeth |
RA Worm | 1:180 gear ratio |
DEC Worm | 1:180 gear ratio |
Power Requirement | 12V DC |
Go2Nova Controller | Yes |
Tracking Rate | Sidereal, Solar, Lunar |
GPS | Yes |
Communication Ports | USB |
Explains the function of each key on the Go2Nova® 8409 hand controller.
Describes the LCD screen of the 8409 HC and its initial information display.
Details the step-by-step process for assembling the CEM26 mount.
Instructions on how to set up the tripod for the CEM26 mount.
Instructions for attaching the mount head to the tripod.
Guide on how to adjust the latitude of the CEM26 mount.
Instructions for installing the counterweight shaft onto the mount.
Guide on how to install the counterweight onto the shaft.
Instructions for installing a telescope onto the CEM26 mount's dovetail saddle.
Instructions on how to balance the telescope and accessories on the mount.
Guide on connecting the necessary cables for mount operation.
Instructions on setting the time, date, and location on the hand controller.
Details how to manually enter or confirm observation site coordinates.
Instructions for performing polar alignment using iPolar or optical polar scope.
Describes the BrightStar Polar Alignment method using two bright stars.
Instructions on returning the mount to its Zero Position after alignment.
Covers mount assembly, balancing, powering on, and polar alignment.
Details one-star and sync-to-target alignment procedures for better accuracy.
Explains the alignment functions for celestial pole and sky model calibration.
Details the procedure for performing a one-star alignment for GOTO accuracy.
Describes the process for improving polar alignment using two stars.
Explains the three-star alignment process for better GOTO model accuracy.
Instructions on setting the correct time and geographical site information.