EasyManuals Logo

iOptron CEM26 User Manual

iOptron CEM26
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
31
6. Maintenance and Servicing
6.1. Maintenance
Do not overload the mount. Do not drop the mount as this will damage the mount and / or
permanently degrade GoTo performance and tracking accuracy. Use a wet cloth to clean the mount and
hand controller. Do not use solvent.
The mount worm/gear meshing can be adjusted to accommodate payload or temperature changed.
Please refer to the instruction in Appendix.
The real time clock battery in the hand controller needs be replaced if it can’t keep the time after
power off the mount.
If your mount is not to be used for an extended period, dismount the OTAs and counterweight(s).
6.2. iOptron Customer Service
If you have any question concerning your mount, please contact iOptron Customer Service
Department. It is strongly suggested to send technical questions to support@ioptron.com for prompt
response during off hour. Customer Service hours are 9:00 AM to 5:00 PM, Eastern Time, Monday through
Friday. Call in the U.S. 1.781.569.0200.
In the unlikely event that the mount requires factory servicing or repairing, write or call iOptron
Customer Service Department first to receive a RMA# before returning the mount to the factory. Please
provide details as to the nature of the problem as well as your name, address, e-mail address, purchase
info and daytime telephone number. We have found that most problems can be resolved by e-mails or
telephone calls. So please contact iOptron first to avoid returning the mount for repair.
6.3. Product End of Life Disposal Instructions
This electronic product is subject to disposal and recycling regulations that vary by
country and region. It is your responsibility to recycle your electronic equipment per your local
environmental laws and regulations to ensure that it will be recycled in a manner that protects
human health and the environment. To find out where you can drop off your waste equipment
for recycling, please contact your local waste recycle/disposal service or the product
representative.
6.4. Battery Replacement and Disposal Instructions
Battery Disposal- Batteries contain chemicals that, if released, may affect the
environment and human health. Batteries should be collected separately for recycling, and
recycled at a local hazardous material disposal location adhering to your country and local
government regulations. To find out where you can drop off your waste battery for recycling,
please contact your local waste disposal service or the product representative.

Table of Contents

Other manuals for iOptron CEM26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the iOptron CEM26 and is the answer not in the manual?

iOptron CEM26 Specifications

General IconGeneral
Payload Capacity26 lbs (11.8 kg)
RA Worm Wheel180 teeth
DEC Worm Wheel180 teeth
RA Worm1:180 gear ratio
DEC Worm1:180 gear ratio
Power Requirement12V DC
Go2Nova ControllerYes
Tracking RateSidereal, Solar, Lunar
GPSYes
Communication PortsUSB

Related product manuals