speed on bends is therefore not a malfunction, but a feature which increases the
machine's stability in all conditions.
i INFORMATION
To set the most suitable head pressure value and solution flow, press the brush
button (fig. A, ref. 8) brushes on.
• Press the brush button (fig. A, ref. 8) to enable all functions (brush and suction motors
and head actuator).
• Select the most suitable pressure for the head on the floor according to the type of
washing to be performed using the buttons (fig. A, ref. 7).
• Select the most suitable flow according to the type of washing to be performed using
the button (fig. A, ref. 3). There are four options
1 STANDARD, the solution flow can be modified using the buttons (fig. A, ref. 2)
2 AUTOMATIC, the solution flow is set by the machine according to the speed.
3 ECONOMY, the solution flow is fixed at the lowest level.
4 CHEM-DOSE enables the concentrated detergent pump (OPTIONAL)
.
To enter
CHEM-DOS mode, hold the button (fig. A, ref. 3) down until the red LED
corresponding to CHEM-DOS comes on. Press the button (fig. A, ref. 3) to
disable the other three programmes (STANDARD, AUTOMATIC, ECONOMY).
The quantity of detergent can now be adjusted using the buttons (fig. A, ref. 2)
and the value set appears on the display (fig. A, ref. 6). When in CHEM-DOSE
mode, you must always select the type of solution flow (STANDARD,
AUTOMATIC, ECONOMY) using the button (fig. A, ref. 3). To exit the CHEM-
DOSE programme, hold the button (fig. A, ref. 3) down for at least 5
seconds.
• Start cleaning, manoeuvring with the hands on the steering wheel (fig. B, ref. 9) and
moving the machine forwards or backwards by pressing the pedal (fig. B, ref. 7).
• The working speed can be set using the maximum speed regulator (fig. A, ref. 13).
IMPORTANT
To avoid damaging the surface of the floor to be treated, avoid rotating the
brushes/pads with the machine stationary.
Stopping:
• Release the pedal (fig. B, ref. 7)
• The machine does not have a parking brake as it is fitted with an electromagnetic
brake which automatically brakes the machine when the drive pedal is not pressed.
• To stop all functions, press the brush button (fig. A, ref. 8).
• Turn the key switch (fig. A, ref. 1) to the "0" position.
Running down of the batteries during work:
IMPORTANT
To avoid damaging the batteries and shortening their working life, do not continue
using the machine once the batteries are flat.
The meaning of the battery charge control light (fig. A, ref. 5) is given below:
To Next Page
Loading...
