concentrations. Do not use solvents or hydrocarbons. The temperature of the
water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made
specifically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section "Safety
regulations".
6.6. Preparing the machine for work
IMPORTANT
Before starting work, wear overalls, ear protectors, non-slip waterproof shoes,
mask to protect the respiratory tract, gloves and all other personal protection
devices recommended by the supplier of the detergent used or necessitated by the
work environment.
Before starting work, proceed as follows:
• check the battery charge (recharge if necessary);
• make sure the dirty water drum (fig. 2, ref. 2) is empty. If necessary, empty it;
• via the opening at the front, fill the detergent tank (fig. 2, ref. 3) with a suitable
concentration of clean water and low-foam detergent. Leave at least 5 cm between the
surface of the liquid and the opening of the tank;
• if the machine is fitted with the optional CHEM DOSE accessory, remove the cap (fig.
3, ref. 1) and fill the tank with appropriately diluted low-foam detergent.
• mount the most suitable brushes or drive disks for the floor and work to be performed
(see paragraph 3.4);
• make sure the squeegee (fig. 2, ref. 6) is firmly attached and connected to the suction
hose (fig. 7, ref. 4). Make sure the back blade is not worn.
• Adjust the height of the control panel support by pressing the locking lever (fig. 14, ref.
1) and with the other hand raise the mount support. When the device has been
released, raise or lower the support into the desired position.
i INFORMATION
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
Always empty the dirty water drum before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, follow a few simple
rules:
• prepare the work area by removing all possible obstacles;
• begin working from the furthermost point to avoid walking on the area you have just
cleaned;
• choose the straightest possible working routes;
• divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible to the
scrubber drier.
6.7. Working
After setting up the machine, proceed as follows:
• start the machine by turning the key clockwise (fig. 5, ref. 1).
• pressing the brush button (LED on) (fig. 5, ref. 4) enables operation of the head and
suction motor. If the machine is set to also operate using the MICRO SCRUB/ECS
To Next Page
Loading...
