• disconnect the batteries;
• empty and clean the dirty water drum.
6.8. Some useful tips to get the most from your scrubber drier
•
In the event of particularly stubborn dirt on the floor, washing and drying can be
performed in two separate operations.
6.8.1. Prewashing with brushes or pads
• adjust the detergent flow (fig. 5, ref. 5);
• press the brush button (fig. 5, ref. 4) (LED on);
• stop the suction motor by pressing the button (fig. 5, ref. 3) (LED off);
• begin washing.
The flow of water must be adjusted in proportion to the desired advance speed. The
slower the machine moves forwards, the less water is needed.
Persist when washing particularly dirty points to give the detergent time to perform its
mechanical action detaching and suspending the dirt and the brushes time to exert an
effective mechanical action.
6.8.2. Drying
Turn the suction motor on by pressing the button (fig. 5, ref. 3), then pass over the same
area washed previously. The result is equivalent to in-depth washing and subsequent
ordinary maintenance will take less time.
6.9. Draining the dirty water
! DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply.
The dirty water drum drain hose is at the back left side of the machine.
To empty the drum:
• move the machine near a drain;
• detach the drain hose (fig. 9, ref. 2) from its seat by holding it near the fixing spring (fig.
9, ref. 3) and pulling horizontally;
• keeping the hose end as high as possible, unscrew and remove the cap (fig. 9, ref. 4);
• lower the hose end gradually, controlling the intensity of the flow of water by adjusting
the height from the ground;
• check the amount of dirt left in the dirty water drum and if necessary wash it out. To
facilitate cleaning and complete emptying of the drum, you are recommended to
unfasten and lift it;
• when the dirty water has been totally drained, lower the dirty water drum (if previously
lifted);
• close the drain hose (fig. 9, ref. 4) by replacing the cap (fig. fig. 9, ref. 2), check that it is
tightly closed and replace the hose in its housing.
IMPORTANT
When washing the dirty water drum, never remove the suction filter (fig. 11, ref. 2)
from its housing and never direct the jet of water against the filter itself.
You are then ready to wash and dry again.
6.10. Draining the clean water
! DANGER
Use suitable personal protection devices.
Drain the water with the machine disconnected from the power supply.
To Next Page
Loading...
