• the battery has been charged
beyond the limit suggested by
the Manufacturer
• replace the battery
ALARMS ON THE DISPLAY
1) ACC "drive lever" already pressed when the machine is turned on or after an Emergency
2) SIC Emergency button pressed
3) POT Speed potentiometer fault
4) MOS Board (mosfet) short circuit
5) HOT Motor thermal cutout tripped
6) LIM Board (mosfet) thermal limitation problem
7) BLT Drive block. Appears when the battery voltage is too low and the drive is blocked.
8) AcS Brush Control Fault Appears when there is a fault in the solenoid switch controlling
the brushes.
9) AcA Suction control fault. Appears when there is a fault in the solenoid switch controlling
suction.
10) FuP Fuse. Appears when the fuse is blown.
To Next Page
Loading...
