IPC Gansow Ct100 - Component Checks and Maintenance; Filter and Squeegee Inspection; Brush Attachment and Release; Squeegee Blade Replacement

2
Checkthesuctionlterisundamagedand
clean.
Checkthedetergenttanklllterisundama-
ged and clean.
Checkthedetergentoutputlterisundamaged
and clean.
Clean the brushes.
Check the squeegee is clean and the blades
are not damaged.
Check the battery charge shown on the display.
To charge, insert the battery charger connector
into the connector alongside the squeegee
lifting lever.
REPLACING THE SQUEEGEE BLADES
• release the clip;
• remove the two blade retainers by pushing them towards the outside of the squeegee then extracting them;
• remove the blade;
• reusethesamebladebyreversingtheedgeincontactwiththeooruntilallfouredgesarewornout,orreplacewithanewblade,ttingitonto
the screws on the body of the squeegee;
• repositionthetwobladeretainersbycentringthewidestpartoftheslotsoverthexingscrewsonthesqueegeebody,thenpushingtheblade
retainers inwards;
• fasten the clip;
BRUSH ATTACHMENT/RELEASE
Attaching:
insert the brushes under the head, making sure they rest against the aligners. Hold the automatic
brush attachment button down until they are attached.
Releasing:
lift the head using the lift button, then press the release button.
THE MACHINE DOES NOT COME ON/START UP CHECK THE BATTERY CHARGE
THE SUCTION MOTOR DOES NOT WORK CHECK THE DIRTY WATER DRUM IS NOT FULL
CHECK THE SQUEEGEE IS LOWERED IN THE WORKING POSITION
THE MACHINE LEAVES THE FLOOR WET CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE
CHECK THE SUCTION FILTER IS UNDAMAGED AND CLEAN
CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY
CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE
THE MACHINE LEAVES THE FLOOR DIRTY CHECK THE TYPE OF BRUSH/PAD IN USE IS SUITABLE FOR THE TYPE OF DIRT AND FLOOR
THE MACHINE LEAVES STRIPES OF WET FLOOR CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED
PLDC01855