GB
Batteries: removal
! DANGER!
When removing the batteries, the operator must be equipped with suitable personal protec-
tion devices (gloves, goggles, overalls, safety shoes, etc.) to reduce the risk of injury. Make
sure the switches on the control panel are in the “0” position (off) and the machine is turned
off. Keep away from naked ames, do not short circuit the battery poles, do not cause sparks
and do not smoke. Proceed as follows.
► Disconnect the battery cables and bridge terminals from the battery poles.
► If necessary, remove the devices xing the battery to the base of the machine.
► Lift the batteries from the compartment using suitable lifting equipment.
Choosing a battery charger
Make sure the battery charger is compatible with the batteries to be charged.
Tubular lead batteries: an automatic charger is recommended. Consult the battery charger manu-
facturer and manual to conrm the choice.
Gel batteries: use a charger specic for this type of battery.
Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must t it with the connector
supplied with the machine.
Proceed as follows to t the connector.
Remove about 13 mm of protective sheath from the red and black cables of the battery charger.
Insert the wires into the connector contacts and squeeze them forcefully with suitable pliers.
Respect the polarity (red wire + black wire –) when inserting the wires into the connector.
Preparing the engine (Petrol and Dual Power versions)
► Fill the fuel tank.
► Check the engine oil level.
Preparing the hydraulic circuit (Petrol and Diesel versions)
► Check the hydraulic oil level.
Fitting the side brushes
See the “Replacing/installing the side brushes” section.
! IMPORTANT!
Follow the instructions given below to congure the machine’s control software to use the
display language you require.
See the “Technical menu” section.
17
To Next Page
Loading...
