IPC Gansow 1250 - Troubleshooting

GB
TROUBLESHOOTING
B= Battery
DP= Dual Power
P= Petrol
D= Diesel
PROBLEM CAUSE REMEDY
The machine raises dust. Filter clogged. (B,DP,P,D) Shake the lter with the lter shaker
and, if necessary, remove and clean it
thoroughly.
Filter damaged. (B,DP,P,D) Replace the lter.
Filter incorrectly tted. (B,DP,P,D) Fit the lter correctly in its housing.
The machine leaves dirt on the ground. The main brush is not adjusted correctly
or is worn. (B,DP,P,D)
Adjust or replace the main brush as nec-
essary.
The main brush has collected string or
wire. (B,DP,P,D)
Remove the string and wire picked up.
The aps are damaged. (B,DP,P,D) Replace the aps.
Debris bin full. (B,DP,P,D) Empty the debris bin.
The main brush does not rotate. Belt broken. (B,DP,P,D) Replace.
Fuse burned out. (B,DP) Replace.
Microswitch faulty. (B,DP) Replace.
Cable disconnected. (B,DP) Check.
Gearmotor faulty. (B,DP) Replace.
The side brushes do not rotate. Belt broken. (P,D) Replace.
Cutout tripped. (B,DP) Reset.
Microswitch faulty. (B,DP) Replace.
Cable disconnected. (B,DP) Check.
The suction motor does not work. Fuse burned out. (B,DP) Replace.
Switch faulty. (B,DP) Replace.
Cable disconnected. (B,DP) Check.
Motor faulty. (B,DP) Replace.
The lter shaker motor does not work. Fuse burned out. (B,DP,P,D) Replace.
Switch faulty. (B,DP,P,D) Replace.
Cable disconnected. (B,DP,P,D) Check.
Motor faulty. (B,DP,P,D) Replace.
35