WARNING
Starting the Engine (Generator)
Select the Fuel Source (Gasoline)
1. Make certain the propane cylinder knob is fully
closed.
2. Add gasoline to the fuel tank.
4a. Recoil Start
4b. Turn the starting dial switch knob to the ON
position.
Pull recoil starter slowly until resistance is felt,
then pull rapidly.
Select the Fuel Source (Propane/LPG)
1. Connect the LPG gas hose to the propane fuel
source. Connect the small end of the LPG gas
hose to the LPG inlet on generator and then
snug with a wrench to prevent leakage.
2. Fully open the Propane/LPG cylinder knob.
Push and hold the button for 3 second.
when the Voltage Selector Switch in in the “120V”
position.
Only change the Voltage Selector Switch with the
generator OFF. DO NOT switch the voltage while the
generator is running or powering appliances.
Page 20
3. Turn the starting dial switch to the ON position.
PUSH
4a. Electric Start
To Next Page
Loading...
