Iridium 9500 - Page 12

DIAL-UP DATA ---------------------------------------------------------------------------------------------- WINDOWS 95/98/Me SETUP
3. In the Make a New Connection window, you must do the following:
In the Telephone number box, enter the telephone number you wish to use for your
connection. Enter the number in international dialing format:
•
•
00 + Country Code + Area Code/Phone Number.
For example, if you are dialing an ISP in Tempe, Arizona, USA, you would enter
00 1 480 555 5555, where 1 is the country code and 480.555.5555 is the ISP’s telephone
number. Please note that this is not a valid telephone number!
Note: This is the same dialing pattern used for voice calls. In fact, you can verify that you are dialing
the correct number for your ISP by dialing the number as a voice call on your satellite phone. You
should hear your ISP’s modem tones if dialed properly.
Leave the Area Code box blank
Click Next >.
4. Click Finish to save your new Dial-Up Networking connection.
Iridium Satellite LLC 12 Rev. 4; February 1, 2002