1. Introduction
The IRIScan™ Book 3 is designed to be used on its own, disconnected from any computer. The documents you scan are stored on the
scanner's microSD card. Then, you can transfer them to your computer and turn them into editable documents thanks to the IRIS’
flagship OCR software Readiris™ Pro.
Note that the IRIScan™ Book 3 is not a Twain-based scanner that can be used from within any application to scan documents. Instead,
think of it as an external storage device that is able to scan independently.
2. Software installation
2.1 Registration and installation
TIP: Check the System Requirements to make sure your system is compatible.
1. Go to http://www.irislink.com/start
2. Then click Start now.
3. Complete the form and click Register now.
4. Select the required Operating System.
5. Click Download to download the software.
6. Go to the location where you downloaded the software, and run the installation file.
7. The following setup screen is displayed:
8. Click Readiris™ Pro to install it. Follow the on-screen instructions.
9. Connect your scanner when needed.
To Next Page
Loading...
Need help?
General
