8 For more information, visit global.irobot.com
EN
Cleaning the Front Caster Wheel
Pull firmly on the front wheel module to remove it
from the robot.
Pull firmly on the wheel to remove it from its housing
(see illustration below).
Remove any debris from inside the wheel cavity.
Reinstall all parts when finished.
Make sure that the wheel clicks back into place.
Important: A front wheel clogged with hair and debris
could result in damage to your floor. If the wheel is not
spinning freely after you have cleaned it, please contact
Customer Care.
1
2
3
4
Wheel
Axle
Housing
Washing the Bin
Make sure that bin is completely
dry. Reinsert filter and place bin
back in the robot.
3
Important: Do not wash the
filter. Remove the filter before
washing the bin.
Release the bin, remove the
filter and open the bin door.
1
Note: Bin is not dishwasher safe.
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
Cleaning the Edge-Sweeping Brush
1
2
Rinse the bin using
warm water.
2
EN
To Next Page
Loading...
Need help?
General
