10 For more information, visit global.irobot.com
EN
Note: Do not spray
cleaning solution
directly onto
sensors or into
sensor openings.
Cleaning the Visual Docking
Target and Charging Contacts
Inspect the visual
docking target and
charging contacts to
make sure that they
are clear of debris.
Wipe with a clean,
dry cloth.
Removing debris from
Blower Cover
Inspect blower
cover for any lint
or debris build-up,
and wipe with a
clean dry cloth to
remove.
Note: To achieve optimal performance
with your robot and automatic dirt
disposal, clean and/or replace your
robot’s filter as needed.
Install a new bag, sliding the plastic
card into the guide rails.
Discard the used bag.
Press down on the lid making
sure that it is completely
closed.
4
3
5
Note: This will seal the
bag so dust and debris
cannot escape.
Replacing the Bag
Pull up on the plastic card to remove the
bag from the canister.
Lift up on the canister lid to open.
1
2
To Next Page
Loading...
Need help?
General
