Roomba
®
i5+ Owner’s Guide 7
EN
Pinch the brush frame release tab, lift
the tab, and remove any obstructions.
Remove the brushes from the robot.
Remove the brush caps from the ends of
the brushes. Remove any hair or debris
that has collected beneath the caps.
Reinstall the brush caps.
Cleaning the Multi-Surface Brushes
Remove any hair or debris from the
square and hexagonal pegs on the
opposite side of the brushes.
Remove the bin from the robot and clear
any debris from the vacuum path.
Reinstall the brushes in the robot. Match
the shape of the brush pegs with the
shape of the brush icons in the cleaning
head module.
1
2
3
4
5
Cleaning the Front Caster Wheel
Pull rmly on the front wheel module to
remove it from the robot.
Pull rmly on the wheel to remove it from
its housing (see illustration below).
Remove any debris from inside the
wheel cavity.
Reinstall all parts when nished. Make
sure the wheel clicks back into place.
Important: A front wheel clogged with
hair and debris could result in damage
to your oor. If the wheel is not spinning
freely after you have cleaned it, please
contact Customer Care.
1
2
3
4
Wheel
Axle
Housing
To Next Page
Loading...
Need help?
General
