iroda SOLDERPRO 50K - Description

HOW TO USE THE
SOLDERPRO 50K
6 7
REFILLING
IGNITION
• Useonlyhigh-qualitybutanegas.
• Rellinawell-ventilatedareaawayfromanyignition
sourceandotherpeople.
1. Holdbutanecanisterupsidedownwhenlling(Fig.1)
2. FirmlypresscanisternozzleintoGas Filling Valve.
3. Releasecanisterwhengasstartstooverow.
(Gasoverowduringrellingisnormalanddoesnot
indicatealeak)
4. Waitforafewminutesbeforeuse.
1. PushtheON/OFF leverupwardandtothe
right,andsettomidposition.(Fig.2)
2. IgnitethegasstreamwiththeFlint Ignitor
locatedontheTorchCap.(Fig.3aFig.3b)
(Youcanalsousearegularlighter.)Thetip
willameforafewsecondsandthenthe
catalystwillchangetoanorangeglow.
Fig.1
Fig.2
Fig.3a Fig.3b
Fig.1
Butane