iroda SOLDERPRO 50K - Temperature Adjustment

IGNITION WARNINGS
8 9
TEMPERATURE ADJUSTMENT
• DonottouchTip,TipHousingorKnurledNutwhileigniting.(Fig.4)
• DonotignitetorchwhenTipAssemblyisnotscrewedon.(Fig.5)
• ThetiptemperaturecanbeadjustedbyturningtheON/OFF Gas
Control Leverleftorright.(Fig.6)
• Settomid-positionwhensolderingorbrazing.
• Excessivegasow,are-uporcatalystpulsingredmayoccur
whentheGas Control Leverissettoohigh.
Fig.4 Fig.5 Fig.6