Page 5 of 16
BB067Installation Guide
©Copyright 2022 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
9. Insert crush tubes into holes
previously drilled in front cross
member.
HINT: Use short bolts from fitting kit
to temporarily hold crush tubes in
position during istallation.
8. Mount chassis support brackets to
inner and outer faces of chassis
using hardware provided.
Do not tighten.
Use trimmed washer for bolt on
inside of tie down point.
To Next Page
