Ironman4x4 BBR084 - Page 2

Page 2 of 26
BBR084 Installation Guide
©Copyright 2024 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
Document Number: BBR084/260424
Pre-Installation Procedures
SAFETY WARNING
• It is always good practice to disconnect the battery while working on 12 Volt systems.
- Please check the owner’s manual for vehicle-specific requirements as some models may need battery backup.
• Auto electrical work should be carried out by a competent person. Vehicle wire colours are listed as a guide only and may
vary on some makes and models.
• The function of each wire should be checked before any connections are made. All wires tapped into should be soldered and
then insulated with electrical tape or heat shrink.
• Grounding/Earth points must always be connected to the factory grounding points, not to the battery negative terminal. See
owner’s manual.
• Using only a LED test light, test all electrical components of the vehicle before and after wiring. This is to ensure everything
works correctly.
• Ironman 4x4 does not recommend the installation of large or light-coloured antennas or aerials to the front of a bull bar as
this may cause the lane departure system to malfunction.
NOTE
• Only a competent person should perform accessory installations. It is the responsibility of this person to ensure correct
fitment.
• Whilst working on this vehicle, always use appropriate safety equipment.
• Read and understand instructions fully before commencing fitment.
• Check the hardware supplied against the contents list on the following pages.
• Do not use this product for any vehicle make or model other than specified in these instructions.
• This product and or hardware must not be modified in any way. Do not remove labels from this product.
• Recording the batch number on the customer’s job card is good practice for future reference, or complete the information
below and file with customer job card.
CARE INSTRUCTIONS
• To maintain the finish of the product, wash regularly using a PH neutral car wash, hose off and chamois dry.
• Do not use acidic or alkaline cleaners.
• Plastic components can be maintained with a silicone spray or similar (non-acidic or alkaline based).
CUSTOMER INFORMATION
Customer Name: Date:
Contact:
Part Number: Batch Number:
(Located on label behind bull bar wing)
#