1. Push up the black button to open the
folding lever, and lift up the stem until you
align it. Twist the knob clockwise to tighten
the folding mechanism. Close the folding
lever until you hear a "CLICK" sound.
2. Connect all of the wires coming from the
stem according to the connector pins.
Assembly
1
2
3. Install the handlebar into the stem. Install
the 6 PCS screws (two on each side) into the
holes, then tighten each screw properly with
the included hex wrench. (Tips: Don't tighten
only one side one time, visit www.isin-
wheel.com for additional help with assembly,
including a step-by-step video.)
4.Make sure that the scooter's turned off. To
fold, push up the black button, then open the
white folding mechanism, and bend the
handlebar.
3 4
To Next Page
Loading...
