Ismart LTC-A2001NV2 - Pan;Tilt;Zoom; System

40
Pan/Tilt/Zoom
PAN/TILT/ZOOM is used to change
pan/tilt/zoom value, available options:
PAN/TILT SPEED: 1, 2, 3, 4, 5, 6, 7, 8 the
bigger the number is, the faster the speed
is.
D-ZOOM LIMIT: X1, X2, X3, X4, X5, X6, X7,
X8, X9, X10, X11, X12.
PTZ TRIG AF: Turn ON / OFF the auto
focus when the camera pans / tilts / zooms.
RATIO SPEED (ON, OFF): Set the relation
of PT speed as per zoom time. When it’s on,
PTZ speed will be faster when zoom time is
bigger.
POWER UP ACTION: PRESET 1, PRESET
2, PRESET 3, PRESET 4, PRESET 5,
PRESET 6, PRESET 7, PRESET 8,
PRESET 9, HOME.
System
ADDRESS: 1, 2, 3, 4, 5, 6, 7.
PROTOCOL: VISCA, PELCO-D, PELCO-P;
BAUD RATE: 2400, 4800, 9600, 38400;
IR ADDRESS: 1,2,3,4, set camera address
to be controlled by remote controller.
VIDEO FORMAT: 1080P60, 1080P50,
1080P30, 1080P25, 1080I60, 1080I50,
720P60, 720P50;
MOUNT MODE: STAND, CEILING;
RS485 PORT:
HALF-DUPLEX-1: the camera will not return
ACK/FINISH/FAULT msg.
HALF-DUPLEX-2: the camera will return
ACK/FINISH/FAULT msg.
LANGUAGE: ENGLISH
<SYSTEM>
ADDRESS 1
PROTOCOL VISCA
BAUD RATE 9600
IR ADDRESS 1
VIDEO FORMAT 1080I50
MOUNT MODE STAND
RS485 PORT HALF-DUPLEX-1
LANGUAGE ENGLISH
SELECT BACK
<PAN TILT ZOOM>
PAN/TILT SPEED 8
D-ZOOM LIMIT X1
PTZ TRIG AF ON
RATIO SPEED ON
POWER UP ACTION HOME
SELECT BACK