EasyManuals Logo

ISON IS-DG500 Series User Manual

Default Icon
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
11
3.2 Enable Mode Commands
All the “show - -” commands in this section can also be executed under any other command
mode except Initialize Mode.
3.2.1 configure terminal
Description
Enter configuration mode.
Syntax
configure
Parameter
None
3.2.2 disable
Description
Enter init mode.
Syntax
disable
Parameter
None
3.2.3 show ntp status
Description
Show SNTP information.
Syntax
show sntp
Parameter
None
3.2.4 show users
Description
Show account list.
Syntax
show account
Parameter
None
3.2.5 show running-cfg
Description
Show running configuration.
Syntax
show running-cfg
Parameter
None
3.2.6 show running-config interface
Description
Show default running configuration.
Syntax
show running-config interface vlan <vlan_list> [ all-defaults]
Parameter
None
3.2.7 show version
Description
Show firmware hardware and software status update status.
Syntax
show version
Parameter
None
3.2.8 show clock
Description
Show current time.
Syntax
Show clock
Parameter
None
3.2.9 show version
Description
Show version information.
Syntax
show version
Parameter
None
3.2.10 show system inventory
Description
Show system inventory.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ISON IS-DG500 Series and is the answer not in the manual?

ISON IS-DG500 Series Specifications

General IconGeneral
BrandISON
ModelIS-DG500 Series
CategoryNetwork Router
LanguageEnglish