To Next PageTo Next PageWhat to do if Isotech Measuring Instruments unit fails to operate?
If your Isotech Measuring Instruments unit fails to operate, first check the fuse. If the fuse blows repeatedly, it is advised to consult Isotech or your local agent for further assistance.
Why is my Isotech Fast-Cal Measuring Instruments unit unstable?
The instability of your Isotech Measuring Instruments unit might be due to interference with the control parameters. In this case, it's best to consult your local agent for assistance.
How to establish PC Communications with Isotech Fast-Cal?
To establish PC Communications with your Isotech Measuring Instruments, follow these steps: * For RS232, ensure you are using the Isotech adapter cable. * Verify that the addresses of the controller and indicator match those set in Cal Notepad. * Confirm that each controller and indicator is set to a unique address.
General| Brand | Isotech |
|---|---|
| Model | Fast-Cal Series |
| Category | Measuring Instruments |
| Language | English |
Essential safety precautions for electrical connection and operation.
Specifies operating temperature and humidity limits.
Details the block function for fast, convenient calibration.
Describes the block function for fast, convenient calibration.
Explains how the controller reads calibration volume/block temperature.
Role of the controller in setting temperature and creating an isothermal environment.
Identifies and explains the function of front panel controls and displays.
Describes the dual display and function of the temperature controller.
Instructions on how to change the desired temperature setpoint using UP/DOWN keys.
Details the advanced feature for controlling heating/cooling rates.
Procedure for selecting the sensor type (PRT or TC).
Critical safety warning about handling hot inserts.
Configuration parameters for sensor input type, units, and range.
Settings for calibration points, offsets, and serial numbers.
Communication settings including address, baud rate, and parity.
