Isotech Fast-Cal Series - Specifications (HTM 2010 & Low Models)

Page 13 of 29
Fast Cal Series Iss.07 – 08/13
SPECIFICATIONS (HTM 2010 & LOW MODELS)
HTM 2010
LOW
Voltage
230VAC or 115VAC
see ratings plate
230VAC or 115VAC
see ratings plate
Power
150W
150W
Supply Frequency
50/60Hz
50/60Hz
Maximum Operating Temperature
140°C
140°C
Minimum Operating Temperature
-55°C below ambient
-55°C below ambient
Stability (Absolute over 30 minutes) Basic / Site
0.02°C
0.02°C
Accuracy - Basic
- Site
±0.2°C
±0.15°C
±0.2°C
±0.15°C
Calibration Volume
5 x 148mm wells
25mm dia x 148mm
Standard Block Hole Dimensions:
1 x 8.0mm dia +
1 x 6.50mm dia +
3 x 4.50mm dia
(Fixed Block)
1 x 8.0mm dia +
1 x 6.50mm dia +
2 x 4.50mm dia
Dimensions (not including handle)
Height 228mm
Width 248mm
Depth 143mm
Height 228mm
Width 248mm
Depth 143mm
Weight
6.60Kg
6.60Kg