Page 27 of 29
Fast Cal Series Iss.07 – 08/13
APPENDIX 1: TROUBLE SHOOTING
Unit fails to operate
Check fuse, if fuse blows repeatedly consult Isotech or local agent.
Unit unstable
Control parameters have been interfered with - consult your local agent.
Cannot establish PC Communications
For RS232 you must use the Isotech adaptor cable.
Ensure the addresses of the controller and indicator match those set in Cal Notepad.
Ensure each controller and indicator is set to a unique address.
Refer to ‘Using the PC Interface’ section and the Cal Notepad manual for further details.
To Next Page
Loading...
