Isotech Fast-Cal Series User Manual

Page 6 of 29
Fast Cal Series Iss.07 – 08/13
‘DO’S AND DON’TS’
DO ensure that after use the equipment is returned to ambient temperature and allowed to reach with 10°C of this
temperature before transporting the equipment or returning to its carrying case.
DO NOT handle the accessories when they are very hot or very cold.
DO NOT place hot or cold accessories back in the carrying case.
DO use that pocket for pre-warming, pre-cooling or storage.
DO NOT rely on the controller to tell you the temperature of the block. Its job is only to provide an isothermal volume. It
is the calibrated working standard that is used to measure actual temperature.
DO NOT calibrate very large sensors in the Fast-Cal units unless you can accept large immersion errors. We have larger
products for larger sensors.
DO NOT try to straighten the working standard, it is deliberately bent so that it does not interfere with the sensors you
are calibrating.

Isotech Fast-Cal Series Specifications

General

Brand	Isotech
Model	Fast-Cal Series
Category	Measuring Instruments
Language	English