Page 9 www.123filter.com | (678) 261-7611 | support@123filter.com
Operation
(1) Installation
Step 1. Choose a suitable location for the system. It must be placed on a flat surface.
Step 2. Install the Removable Drip Tray & Grill at the front of the system.
Step 3. Insert the 1/4" tube into the 1/4" water inlet at the back of the system.
Step 4. Plug in the main power supply to the power socket at the back of the system.
Vibrations can be expected as the pump starts.
Step 5. Prepare a bucket, remove Drain Line Cap at the back of the system, let it run for at
least 30 minutes to flush the system. This should be done each time the filters are changed.
Step 6. Once the rinsing is completed, screw back the Drain Line Cap.
Step 7. The system is ready for use.
To Next Page
Loading...
Need help?
General
