PARTS IDENTIFICATION
HOW TO INSTALL
To fit different plumbing sizes, the unit comes with two types of threads on both ends: 1
inch MNPT, 3/4” FNPT, and 3/4” inch Push-Fit
Please pay attention to the flow direction indicated by the arrow.
• Close the main inlet valve and drain the remaining water from the pipe.
• When installing, make sure that the direction of water flow marked on the valve
body aligns with the direction of water flow in the pipeline.
• After the filter is installed, the filter housing assembly must be kept upright.
Apply plumber’s tape
To Next Page
Loading...
