6A – 60 ENGINE MECHANICAL
RTW36ASH001501
Disassembly
1. Connecting Rod Bearing
If the connecting rod bearings are to be reinstalled, mark
their fitting positions by tagging each bearing with the
cylinder number from which it was removed.
015RW041
2. Piston Ring
1. Clamp the connecting rod in a vise.
Take care not to damage the connecting rod.
2. Use a piston ring replacer to remove the piston rings.
Piston Ring Replacer
Do not attempt to use some other tool to remove the
piston rings. Piston ring stretching will result in
reduced piston ring tension.
3. Piston Pin Snap Ring
Use a pair of pliers to remove the piston pin snap rings.
RTW36ASH001601
4. Piston Pin
5. Connecting Rod
6. Piston
Tap the piston pin out with a hammer and a brass bar.
If the pistons and piston pins are to be reinstalled, mark
their installation positions by tagging each piston and piston
pin with the cylinder number from which it was removed.
F06MV015
To Next Page
Loading...
