2. Tire wear inspection
Note：
・ Inspection of waddling phenomenon of radial
tires
1. Set the vehicle to the running conditions.
2. Check the locations causing the failure.
Note：
・ Inspect to find out whether the cause of the
waddling phenomenon is at the front or rear.
3. Replace the tire.
Note：
・ Install a normal tire and wheel to the location
where the waddle phenomenon is occurring.
・ If you cannot verify the location of the waddling
phenomenon, replace the rear tires.
4. Conduct a test drive.
Note：
・ If there is no change, continue the procedure.
Replace the original tires one by one to track down the
defective tire.
Replace all of the four tires with normal tires, and then
replace the original tires one by one to track down the
defective tire.
Note：
・ Inspection of pulling phenomenon of radial
tires
The rear tires are never the cause of the pulling
phenomenon.
Note：
・ Radial tire pull repair chart
Functional Inspection (All models) 16C-9
To Next Page
Loading...
