iSystem iC5000 - 20-pin 1.27 mm Cortex Debug Adapter Connector Details; Connector Options and Recommendation

 iSYSTEM, October 2016 19/69
Debug Cable Adapters
Various cable adapters are available depending on the specific target architecture and the target debug connector.
They are used to connect iC5000 development system to the target.
Ordering code
Adapter
IC50111-1
20-pin 2.54mm ARM Cable Adapter
IC50112
14-pin 2.54mm ARM Cable Adapter
IC50113-AMP
20-pin 1.27mm AMP Cortex Debug Cable Adapter
IC50114
Mictor 38-pin ARM ETM 8-bit Cable Adapter
IC50115
Mictor 38-pin ARM ETM 16-bit Cable Adapter
IC50116
10-pin 1.27mm Cortex Debug Cable Adapter
IC50118
20-pin 1.27mm Cortex Debug Cable Adapter
IC50119
20-pin 1.27 x 2.54mm Compact TI-20 Cable Adapter
IC50130
26-pin 2.54 mm ColdFire Cable Adapter
IC50140
6-pin 2.54mm BDM Cable Adapter
IC50141
6-pin 2.54mm S12Z Cable Adapter
IC50150
14-pin 2.54mm MPC5xxx Cable Adapter
IC50152
IC50152-12
Mictor 38-pin MPC5xxx Nexus 16-bit Cable Adapter
IC50153
16-pin 2.54mm Freescale COP Cable Adapter
IC50154
51-pin GLENAIR Cable Adapter
IC50155
Mictor 38-pin PPC4xx RISCTrace Cable Adapter
IC50156
50-pin Samtec MPC5xxx Nexus 16-bit Cable Adapter
IC50158
Mictor 38-pin MPC5xx Nexus 8-bit Cable Adapter
IC50160
16-pin 2.54mm Infineon JTAG Cable Adapter
IC50160-ECU14
10-pin 1.27mm Tricore ECU14 Cable Adapter
IC50160-MEDC17
10-pin 1.27mm Tricore MEDC17 Cable Adapter
IC50162
6-pin 2.54mm Infineon I2C Cable Adapter
IC50163
10-pin 1.27mm Infineon DAP2 Wide Cable Adapter
IC50164
22-pin Samtec ERF8 DAP2 Cable Adapter
IC50170
16-pin 2.54mm Renesas 78K0R Serial Cable Adapter
IC50171
20-pin 2.54mm Renesas V850/RH850 Cable Adapter
IC50172
26-pin KEL Renesas V850 Cable Adapter
IC50173
14-pin 2.54mm Renesas SuperH Cable Adapter
IC50174
10-pin 2.54mm Renesas 78K0 Serial Cable Adapter
IC50175
14-pin 2.54mm Renesas RL78 Serial Cable Adapter
IC50176
14-pin 2.54mm Renesas RH850 Cable Adapter
IC50176-EPS
10-pin 1.27mm Renesas RH850 Cable Adapter
IC50177
Mictor 38-pin Renesas RH850 Nexus 16-bit Cable Adapter
IC50190
4-pin ERNI ST STM8 Cable Adapter
Signal direction definition used throughout this document:
O
- output from the debugger to the target microcontroller
I
- input to the debugger from the target microcontroller