To Next PageTo Next Page
Need help?Do you have a question about the ITC 2" and is the answer not in the manual?
Wear approved safety glasses with permanently attached, rigid side shields to prevent eye injuries.
Wear ear protection to safeguard against possible hearing loss.
Use clean, dry, regulated compressed air at 70-90 psi. Do not exceed 200 psi.
Disconnect tool from air supply before disassembly, maintenance, or clearing jams.
Shoots industry standard 18 gauge brad nails in sizes from 15 mm (5/8") to 50 mm (2").
Air consumption is 2-4 cfm / 57-113 litres per min at 414-621 kPa / 60-90 psi.
Includes quick-release nose piece, padded hand grip, and adjustable exhaust deflector.
Operate on clean, dry, regulated air (60-100 psi). Recommended system includes filter, regulator, and oiler.
Turn compressor on, set regulator pressure, then connect tool to air supply. Ensure tool is pointed away from users.
Disconnect tool from air supply, release magazine, load fasteners, and re-secure magazine.
Test fire to set depth. Hold tool perpendicular, press drive guide, squeeze trigger.
Wipe tool clean, inspect for wear/damage, check trigger/safety mechanism, and tighten screws.
Add 2 drops of air tool oil to inlet at start of day and after 1 hour of use. Use only air tool oil.
Check O-rings, trigger valve head, stem, or seals for damage or leaks.
Address issues like driving too deep, skipping fasteners, jamming, or not driving tight.
Two-year warranty against manufacturer faults for DIY use. Excludes misuse, abuse, or alteration.
Warranty does not cover normal wear, consumable parts, or professional/industrial use.
General