To Next Page

To Previous Page

ENGLISH

FRANÇAIS

ENGLISH

v.081122

ENGLISH

FRANÇAIS

ENGLISH

21. STAY ALERT. Keep hands and body away from the path of any potential red

fastener. Watch what you are doing & use common sense. Do not operate

any tool when you are tired.

22. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded

surfaces: pipes, radiators, ranges, and refrigerator enclosures. Before driving

fasteners into walls, oors, or wherever “live” electrical wires may be encoun-

tered, try to ascertain whether there is a danger of shock.

23. KEEP WORK AREA CLEAR of obstructions.

24. EMPLOYERS must enforce compliance with the safety warnings and all other

instructions in this manual. Keep it available for use by everyone assigned to

use this tool.

2” BRAD NAILER

= Shoots industry standard 18 gauge brad nails in the following sizes: 15 mm

(5/8"), 20 mm (3/4"), 25 mm (1"), 30 mm (1-3/16"), 35 mm (1-3/8"), 40 mm

(1-9/16"), 45 mm (1-3/4"), and 50 mm (2").

= These brads are perfect for installing trim and mouldings, for cabinet and fur-

niture making, picture framing, and for applications where gluing is necessary,

but clamping is impractical.

= Air consumption is 2 – 4 cfm / 57-113 litres per min @ 414-621 kPa / 60 to 90

psi.

= Quick-release nose piece.

= Padded hand grip.

= Adjustable exhaust deector

= Air inlet: 1/4" NPT

= Included:

 = S3 hex key

 = S4 hex key

 = Small bottle of air tool oil

= Tool weight: 1.5 kg (3.3 lb)

AIR SYSTEM

= The brad nailer is designed to operate on clean, dry, compressed air, regulated

at 60-100 psi / 413 to 690 kPa / 4.13 to 6.9 bar. The preferred system would

include a lter, a pressure regulator, and an automatic oiler located as close to

the tool as possible (within 15 feet / 5 meters is ideal). Do not use bottled air

or gases. Please see gure below:

= All compressed air contains moisture and other contaminants that can harm

the internal components of the tool. An air line lter will remove most of these

and signicantly prolong the life of the tool. Ensure the in-line oiler has suf-

cient oil. If an in-line oiler is not available, place 2 drops of oil into the tool’s air

inlet at the beginning of each workday. More than this will be expelled from the

tool’s exhaust during ring.

IMPORTANT SAFETY INSTRUCTIONS

SPECIFICATIONS

SETUP & OPERATION

Air Hose

Nailer

Quick Connector

Oiler

Filter Air Supply

Regulator

Brand	ITC
Model	2"
Category	Nail Gun
Language	English

ITC 2" User Manual

Table of Contents

Questions and Answers:

ITC 2" Specifications