To Next Page

To Previous Page

Advanced Function

2. Rotate the knob and select Batt Emulator. Press [Enter] key and enter the

battery emulation function setting page.

3. Rotate the knob to select running battery emulation file (Run), recalling bat-

tery emulation file (Recall) and editing battery emulation file (Edit) in

successive.

Run Recall Edit

4. Select different functions for setting. For details, refer to the introduction of

specific operation.

Edit battery emulation file

1. In the setting interface of battery emulation function, select Edit, and enter

the battery emulation file editing menu.

2. At first, select the number of file to be edited. A maximum of 10 battery emu-

lation files can be edited in this instrument.

Edit Emul = 1/10

3. Edit the following parameters of this battery emulation file in successive.

Press [Enter] key to confirm setting.

1: Cell Properties

2: Parallel =1

3: Series =1

4: I_Limit + = 2.00A

5: I_Limit – = –2.00A

6: - -EXIT- -

• Cell Properties: Set the battery properties, including full-state voltage val-

ue, empty-state voltage value, internal resistance value and capacity val-

ue. The user can conduct setting based on battery specifications to be

emulated.

• Parallel: This function can emulate the state of several batteries in paral-

lel connection. For example, when “2” is set, the battery emulated in the

instrument is a battery group composed of two batteries in parallel

connection.

• Serial: This function can emulate the state of several batteries in serial

connection. For example, when “2” is set, the battery emulated in the in-

strument is a battery group composed of two batteries in serial

connection.

ITech IT-M3412 User Manual

Questions and Answers: